Handwritten or Printed Carton IDs, It Is Not the Pen
Handwriting a carton number works for small volumes and temporary jobs. Once volume climbs, legibility, speed and traceability all become visible problems.
A small warehouse, a short order run, a rework job: grabbing a marker and writing the carton number is faster than starting a printer. Volume changes that. Handwriting starts to show its limits. Two people read the same scrawl as two different numbers at stocktake. The writing blurs into a smear after an hour in a cold store. One swipe of oil and the number is gone. None of this is obvious day to day, until a customer disputes a batch and the whole record turns out to be unreliable.
Where handwriting still holds
A few dozen cartons a day, moving only inside one plant, never scanned into a system: handwriting is fine. Adding a missing carton number or correcting an address by hand is also quicker than setting up a layout. The test is simple. Does anyone outside this room have to read this label, does it have to survive for months, does it have to enter a system. Three noes and a marker is enough.

What printing actually fixes
Legibility first. Typeface, type size and barcode dimensions are fixed, so ten thousand labels look the same. If one will not scan, the cause is the printer or the stock, not an argument about whose handwriting is worse. Speed second: print a sheet of labels, peel and apply, and the job beats writing them one at a time once orders stack up. Data third: carton number, batch and date come straight from the system or the spreadsheet, with no transcription and no memory involved.
The barcode is the real dividing line. A handwritten carton number cannot be scanned, so stocktaking means two people reading numbers aloud to each other. A printed label carries Code 128 or a 2D code, a scanner reads it in one pass, and the record lands in the system. When stock does not match the book, the discrepancy points to a specific carton.
Environment rules out most handwriting
Cold rooms, fish processing, chemical plants and paint shops are not handwriting territory. At low temperature the board frosts over and the marker will not take. In damp air ordinary ink feathers. Oil and solvent wipe the number away. Printed labels are not automatically the answer either: the face stock has to resist moisture and oil, and the ribbon has to resist solvent. Direct thermal darkens and smears through freeze-thaw cycles, so thermal transfer with a resin ribbon is usually the more dependable choice.
The cost argument is not one-sided
A printer plus label stock is capital outlay; a marker costs almost nothing. On consumables alone, handwriting wins. Add labour and the picture shifts. A worker writing two hundred cartons a day at a dozen seconds each spends over ten hours a month on the task, and rework from unreadable numbers adds to it. At higher volume, the comparison reverses quickly.
A staged transition
There is no need to change everything at once. Print the fields that carry real risk first, batch number, date and serial, and keep handwriting for temporary marks. Run it for two months and watch whether rework and stock discrepancies fall, then decide whether carton numbers and bin locations should also be printed. The hardware does not have to be an industrial printer on day one; a desktop unit and a roll of thermal transfer labels will prove the process.
On warehouse projects the bottleneck is rarely the label itself. It is the template and the field list. Get those settled and fixed, and the people on the floor will use the printer. Skip that step and it ends up under a layer of dust in the corner. Label cost per thousand is a rounding error next to the labour it saves, so do not let a few yuan of stock decide the question.

